Go Back   Wiki NewForum | Latest Entertainment News > General Discussion

How to Shrink a Bathing Suit

Views: 1232  
Thread Tools Rate Thread
Old 05-30-2019, 08:31 AM
welcomewiki welcomewiki is offline
Join Date: Dec 2008
Location: India
Posts: 83,636
Default How to Shrink a Bathing Suit

Whether your bathing suit is too large because you lost weight, bought the wrong size, or stretched out the material over time, you may want to shrink the suit rather than investing in a new one. Bathing suits are most often made of materials like lycra, spandex, polyester, and nylon, which make it harder to shrink the fibers, but itís not impossible! Try using boiling hot water to soak your suit and then put it through a hot cycle in the dryer, or try ironing a damp suit on low heat to gradually shrink the material. It may require a couple of attempts, but you should be able to shrink your suit down to the size you prefer.


EditUsing the Dryer
  1. Turn your suit inside out to protect the pigments as much as possible. Before washing, boiling, and drying your suit, make sure itís turned inside out. Doing so will keep the colors from running and your suit should maintain its original hues.[1]
    • If there are any bra inserts, go ahead and remove them at this time.
  2. Wash the suit by hand in cool water to clean off any dirt, grime, or oil. Fill up the sink with cool water, and use a mild laundry detergent that doesnít have any bleach or dyes in it. Wash the bathing suit in the soapy water, then drain the sink and use fresh water to rinse the suit until there are no more suds. If there is residual sunscreen, sweat, oil, sand, or grime on your suit when it goes into the dryer later, that could get baked into the material and make your suit hard and inflexible, so itís important to clean it beforehand.[2]
    • Avoid putting your suit in the washing machine, as the rough tumbling could stretch out the fibers in the suit.
  3. Soak the suit in boiling water until the water cools to room temperature. Use a kettle, the microwave, or a pot on the stove to boil water (make sure to use a large pot or dish that wonít break from the heat). Submerge the suit completely in the boiling water and let it sit in there until the water cools down, which should take about 15 to 20 minutes.[3]
    • The heat from the boiling water should start to shrink the fibers in the suit and prepare it for further shrinkage once it goes into the dryer.
  4. Place the suit into the dryer on the highest setting available. For optimum shrinkage, use the highest setting and the longest time that you can choose. Avoid drying the suit with a full load of laundry, as you want it to receive the highest blast of heat so that it can shrink down as much as possible.[4]
    • Most dryers can run for 60 to 70 minutes before they shut off.
  5. Let the garment cool to room temperature once the dry cycle is done. Instead of taking the hot garment right out of the machine and putting it on, set it to the side to let it cool off. The elastic can hold a lot of heat and might burn you if you were to put it on right away.[5]
    • It shouldnít take more than 10 minutes for the suit to cool off.
  6. Repeat the process 2 to 3 more times to gradually shrink the suit. Try the suit on after it has dried completely to see if itís at the right size yet. If so, thatís great and youíre ready to enjoy your improved suit! If itís still too big, go ahead and repeat the boiling and drying process a few more times (thereís no need to wash the suit again as itís already clean).[6]
    • If the suit doesnít shrink enough after 3 washes, it may be time to consider getting it tailored or perhaps just investing in a new suit.
EditIroning Your Suit
  1. Wash your suit, rinse it out, and thoroughly wring out the excess water. Use cool water and mild laundry detergent thatís free of bleach and added dyes to wash your suit if it isnít already clean. Fill the sink with cool water and apply the soap directly to your suit. Massage the material in the water to create suds and clean away any grime. Drain the sink, then use fresh water to rinse the suit until no more suds are visible. Squeeze the suit by hand until the suit is just damp instead of drenched.[7]
    • If you iron a dirty suit, you are essentially baking in any residual salt, sand, sweat, sunscreen, or lotions you may have come into contact with the last time it was worn.
  2. Cover the suit with a cotton cloth once itís on the ironing board. If you donít have a cotton cloth specifically for ironing, you could also use a handkerchief or some other kind of s**** fabric, just as long as it is clean and made of cotton. Never put the iron directly onto the damp bathing suit, as that will damage the material.[8]
  3. Turn the iron on to a low- or medium-heat setting. To avoid damaging the swimsuit, avoid using high heat. Itíll take a little longer to iron and dry the suit, but in the end, your suit will be in better condition.[9]
    • You donít need to fill the steamer basket in the iron for this process. Because the suit is already wet, you wonít need to add moisture to it.
  4. Iron the suit, pressing down with slow, firm movements. Because youíre using a low-heat setting, be prepared to iron your suit for upwards of 10 minutes. Work systematically from the top to the bottom of the suit, using long, even strokes. Press down with force so that the heat of the iron penetrates through the protective cloth and hits the swimsuit.[10]
    • Even though the iron isnít exuding a ton of heat, still be careful to not catch your fingers or grab the bottom of the iron with your bare hands. Itíll still be hot enough to burn you!
  5. Flip the suit over from time to time to evenly iron both sides. Make sure to work both sides of the suit so you donít end up with one side that shrunk and one side that is still the original size. Try flipping the suit over after going from top to bottom completely.[11]
    • You may also want to wipe off the ironing board with a clean, dry towel when you flip the suit over. If there is excess moisture on the board, you donít want it getting absorbed back up into the side you were just working on.
  6. Continue ironing until almost all of the water has evaporated. It may take 10 minutes or more, so settle in at the ironing board. Continue using adequate pressure and alternating sides so that the suit dries as quickly as possible. Once the majority of the water is gone and the suit is almost completely dry to the touch, you can stop.[12]
    • If you dread the idea of ironing for that long, watch a show or listen to some music while you workóitíll help the time pass more quickly.
  7. Let the suit air dry the rest of the way before wearing it again. Avoid putting your suit into the sun as the heat could mutate the colors and weaken the elastic. Leave it on the ironing board, or hang it up on a clothesline to let it finish drying. Once it is completely dry to the touch, go ahead and try it on. If it isnít as small as youíd like, go ahead and repeat the ironing method another 1 to 2 times. If it isnít shrunken enough after those efforts, it may be time to take it in by hand or invest in a new suit.[13]
    • You could pop the suit into the dryer on high heat for about 20 minutes to finish drying it. This could help the material to shrink even more, but letting it air dry will be gentler on the material.
EditPreventing Stretching
  1. Wash your swimsuit after every use, whether or not it got wet. Sunscreen, lotions, oils, sand, and sweat all need to be washed away on a regular basis to keep your suit in tiptop condition. You may think if you didnít go into the water and thereís no chlorine or salt on your suit that it doesnít need to be washed, but the fibers and elastics will be in much better condition for a longer time if you give the suit a quick wash after every use.[14]
    • Build-up of grime can cause the elastic fibers to deteriorate more quickly over time.
  2. Hand wash your suits in cool water with mild detergent. Avoid using the washing machine if at all possible, as the tumbling motion can stretch your suit and damage the elastic fibers. Use your sink or a bucket to scrub your suit by hand with a mild laundry detergent that is free of bleach and dyes. Once it has been washed, use clean water to thoroughly rinse the suit until all the suds are gone.[15]
  3. Hang your suit to dry instead of using the dryer when possible. After your suit has been washed, go ahead and lay it out somewhere to dry. Avoid putting it over a metal pole, like what you might have in your bathroom, as the metal could react with the material and stain it. Instead, use a clothesline and clothespins to hang the suit by its straps.[16]
    • A dryer is a great way to shrink a suit, but at the same time, it can also weaken the fibers because of the tumbling and the high heat. Itís something that shouldnít be used very often so that your suit stays in the best condition possible.
  4. Keep your drying suit out of the sun to avoid damaging the fibers. It may be super tempting to lay your suit out in the sun to let it dry naturally once youíre finished wearing it, but avoid doing this if you can. In addition to fading the color of your suit, the sun can also weaken the elastic and make your suit less durable over time.[17]
    • If on occasion you canít avoid using the sun to dry your suit, that is okay. Just make it a point to not do it every time.
  5. Keep your suit away from rough surfaces so the material doesnít snag. Concrete, pool chairs, and other materials that are often around swimming areas can snag the fibers of your suit, break them, and cause them to weaken over time. Avoid this by laying a towel down before you sit on a chair or on the ground.[18]
    • If you donít have a towel available, pull on a coverup or something similar before you sit down so that your suit doesnít come into contact with any rough materials.
  • If these options donít work for your suit, you may want to consider having the suit tailored or taking it in yourself, especially if itís still in good condition.
EditThings Youíll Need

EditUsing the Dryer
  • Mild soap
  • Clean bucket or sink
  • Teakettle or microwave
  • Dryer
EditIroning Your Suit
  • Mild soap
  • Cotton cloth
  • Ironing board
  • Iron

Cite error: tags exist, but no tag was found


Reply With Quote

Latest News in General Discussion

Thread Tools
Rate This Thread
Rate This Thread:

Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2022, vBulletin Solutions, Inc.