|
Sending the Inspection Setup Directly |
Views: 2108
|
Thread Tools | Rate Thread |
#1
|
|||
|
|||
Sending the Inspection Setup Directly
Sending the Inspection Setup Directly
Use You use this procedure to manually trigger the distribution of newly created inspection setup data. Prerequisites You must have made the relevant settings in Customizing. Procedure
You can limit the selection further, by entering the plant.
You can enter any target system that is maintained as a logical system. If you did not enter a system, the data is sent to the target system that was entered in the distribution model.
You can delete generically by using placeholders (* or +). The entry is transferred to the target system unchecked, since it is not possible to check against the inspection types in the target system.
One IDoc is created for each material and plant. This means that an IDoc can contain several data segments, if several inspection types are available for a material-plant combination, or if an inspection type to be deleted or placeholder was entered. If there are several materials, then several IDocs are created.
You can automate the processing. This means that the posting of the IDocs takes place immediately and does not have to be triggered manually.
Distributing ALE Master Data Last edited by seema; 11-03-2009 at 11:00 AM. |